top of page
Pure-10 Dryer 21999-1010-MM_edited.png
21999-0715 15 Hp Regenerative Air Dryer
21999-0720 20 Hp Regenerative Air Dryer.
Tsunami Compressed Air Solutions LOGO PA

Por qué usar tsunami

 

En Los sistemas de secado regenerativo Tsunami utilizan tecnología patentada para proporcionar aire extremadamente limpio y seco. El tsunami tiene éxito cuando el aire pretratado entra en el secador regenerativo, donde el desecante de tamiz molecular absorbe el vapor de agua. Aproximadamente cada dos minutos, una señal controlada obliga a un pistón interno a cambiar. El cambio en el pistón redirige el flujo de aire a través del recipiente opuesto mientras simultáneamente hace retroceder una pequeña cantidad de aire seco a través de la torre utilizada anteriormente; ¡Es como cambiar tu desecante cada dos minutos! El secador regenerativo Pure-10P de Tsunami brinda beneficios similares a los secadores de pared Ultra a un costo reducido. Los sistemas Pure-10P utilizan un sistema de control simple y prefiltración de tsunamis con drenajes automáticos Moisture Minder® para asegurar la eliminación de agua, aceite y partículas antes de ingresar a la secadora.

  • ∙ Humedad relativa baja: hasta .01% RH Points Puntos de rocío hasta -80 ° F

  • ∙ Incluye prefiltración (eliminación de agua, aceite y partículas) Dra Los drenajes neumáticos Moisture Minder® eliminan automáticamente los contaminantes capturados antes de ingresar a la secadora

Diseñado alrededor de su tamaño y requisitos del compresor

Tsunami Compressed Air Solutions LOGO PA
240_F_198227577_d7AIY1eDlka9k4eHuTMXKidm

¡El mejor sistema de aire acondicionado de TSUNAMI en la industria SPF!

Cautionary NOTE: (For breathable air source) You must either use the “bypass port” that avoids the descant towers or as seen in the photo below split the air off after the water separator and oil coalescent filter. This line will now go to your D-grade breathable filtration panel prior to reaching the installer’s mask. You need to be aware that a regenerative dryer creates extremely dry air which is what we want in our equipment but not in our lungs. Note: It must be avoided, it has the serious potential to cause lung tissue damage if used through the desiccant towers!

340638996_1681404742308290_8311683157778974783_n.jpg

Bypass the towers

1.

TWO WAYS TO CORRECTLY
RUN A BREATHABLE AIR SOURCE TO A D-GRADE FILTRATION PANEL.

IMG_5498 (1).jpeg

2.

"OUT" Goes to you equipment

The "IN/AUX" is the bypass that avoids the towers.  It goes through the entire block assembly and can flow either way so the "IN" is also the "OUT-AUX" port!

bottom of page